SIKA Top Seal 107 (A + B) 20KG + 5KG Waterproof Waterproofing Cement Based Simen Kalis Air Tandas Kolam Ikan

*Maximum 1 set per order*2 part polymer modified cementitious waterproof mortar slurryComprising of a liquid polymer and a cement based mix incorporating special admixturesIt is applied to concrete and mortar to prevent water infiltrationUSES: SikaTop Seal-107 is used for:Interior and exterior waterproofing and damp-proofing of concrete, cementitious rendering, brickwork and blockworkProtection of concrete structures against the effects of de-icing salts and freeze-thaw attackExterior waterproofing of basement walls in new construction and refurbishmentPore / blowhole fillingRigid waterproofing of water tanks, swimming pools, etc.Sealing fine “hairline” cracks in concrete structures not subject to movementSealing internal basement walls against dampnessLeveling mortar for concrete repair worksPotable concrete water tanksBasementsTerraces and balconiesRetaining wallsSwimming pools and fountainsRC gutters and planter boxesBathroom floorsSeawallsCHARACTERISTICS AND ADVANTAGES:Pre-batched components – mixes and applies easilySlurry or trowellable consistencyGood adhesion to sound, prepared substratesIncreased frost and salt resistanceProtects against concrete carbonation and water penetrationNon toxic – suitable for contact with drinking waterNon corrosive to steel and ironCOLOUR:Part A: white liquid Part B: Grey powder Part A+B: Grey slurryPACKAGING:25 kg/setCoverage Depending on type of application, two (2) coats always required. Three (3) coats may be required in areas of extremely high infiltration.- 1st coat consumption 1-1.5 kg/m2 on damp surface.- 2nd coat consumption 0.8 – 1 kg/m2 approx.Surface Preparation Concrete, mortar and masonry surfaces must be clean, free from grease, oil and loosely adhering particles. All surfaces must be as true and flat as possible. Saturate absorbent surfaces thoroughly with water before application.Application MixingThe consistency of the mix can be altered by reducing the amount of component (A) (liquid) to be used. Under normal circumstances, when the full quantities of both components are mixed together, a slurry consistency will result. For a trowelable consistency use only 90% of component (A) (approx. 4.5 kg) Mix in a clean container by slowly adding the powder component to the liquid component and stirring with slow speed mixer.